Cooper Menvier SD3 Manual do Operador descarregar pdf (Página 31)

Phone Line Fault:

This output type will activate when telephone line connected to the unit has

a fault, i.e. line disconnected or no line voltage after 50 seconds.

Line in Use:

This output type activates when the SD2 is using the telephone line.

Call Active:

This output type activates when the SD2 is active, i.e. after the unit has

been triggered. The output de-activates once the unit has dialled all its

contacts or the call is aborted.

Call Successful:

This output type activates when the SD2 has delivered its message

successfully. The output de-activates when the unit is next triggered.

Call Failed:

This output type activates when the SD2 fails to deliver its message. The

output de-activates when the unit is next triggered.

Remote Control 1:

This output type can be remotely turned on and off by a touchtone

telephone. e.g., switching on lighting or heating/ventilation systems.

Remote Control 2:

This output type can be remotely turned on and off by a touchtone

telephone. e.g., switching on lighting or heating/ventilation systems.

Supply Volts Low:

This output type activates when the SD2 supply voltage drops below 10.5

Volts.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

Sem comentários

Cooper Menvier SD3 Manual do Operador Página 31